During the use of the bending machine, it is necessary to follow certain operating steps to operate it correctly. Below, we will explain the detailed operating process and usage of the bending machine.

Instructions for use mainly focus on standardizing operating procedures to ensure production safety.

1. Basic operating methods:

1.1. The first step is to connect the power supply. On the control console, turn on the operation switch, press the oil pump to start, and the oil pump will rotate and make a sound.

1.2. Adjust the stroke. Pay attention to adjusting the stroke during use of the bending machine, and make sure to debug it before use. When the bending machine travels up and down to the bottom, there must be a gap. If there is no gap, it will cause certain wear and tear to the machine operation. Therefore, manual or electric micro debugging can be performed on the bending machine.

1.3. Selection of bending machine slots, select a slot with a thickness of approximately 8 times the width of the plate. For example, if the thickness of the board is 5 centimeters, the notch needs to be about 40 centimeters.

1.4. The material blocking behind the bending machine also requires certain manual or electric fine adjustments.

1.5. Press the pedal switch to bend, and the pedal switch of the bending machine can be released and pressed at any time. Release it to stop working, and press it to continue bending.

1.6. When the bending machine stops working, turn off the operation switch on the operating platform, then turn off the power, clean the bending machine workbench, and make its surface clean and tidy for future use.

1.7. Pay attention to maintenance and upkeep of the bending machine, which can ensure safe production and long service life of the machine.